Thunder Laser successfull…
How to adjust the laser beam path
How to install new laser tube
-
X-axis not moving at all
Release Time：2018/11/17Browsing Times：820
Here are the reasons: ● X-axis limit switch problem Locate on the left side of x-axis, please check if the wiring and roller lever of switch are well or not, like below. If they both se...
-
Y-axis not moving at all
Release Time：2018/11/17Browsing Times：883
Here are the reasons: ● Rotary switch is turned on Note: The rotary-axis and y-axis can be switched, if the rotary switch is turned on, y-axis will not moving at all, and the rotary-axis will ...
-
Alarm message of LCD panel—Machine protected
Release Time：2018/11/17Browsing Times：771
LCD panel shows the following information: Our machine has sensors for door protection (front cover and laser tube cover), like below. Please close both of them before start to ...
-
Alarm message of LCD panel—Water error
Release Time：2018/11/17Browsing Times：931
LCD panel shows the following information: Here are the reasons: ● Water chiller（water pump）is not turned on Please turn on the water chiller before power on the machine, like below....
-
Alarm message of LCD panel—No enough extend space
Release Time：2018/11/17Browsing Times：738
LCD panel shows the following information: This problem only appears on engraving mode, it’s caused by the buffer distance is out of bound. For example, if you want to engrave a...
-
Alarm message of LCD panel—Frame/X/Y Slop over
Release Time：2018/11/11Browsing Times：928
LCD panel shows the following information: Here are the reasons: ● The size of the graphic is larger than the working area of the machine If your laser cutter’s working area is 600×...
-
Why noisy while moving laser head front and back, how to adjust?
Release Time：2017/01/12Browsing Times：1200
When you move laser head front and back, two couplings make a lot of noise. What is the cause of this? Both sides of transmission shaft are not aligned
-
The machine won’t turn on
Release Time：2017/01/11Browsing Times：763
Here are the reasons: ● Emergency Stop key is pressed If it’s pressed, please reset it, like below. ● The circuit breaker has tripped Locate on the lower right hand door panel (or back si...
