![Thunder Laser successfully wrapped up its tour to Tech Industry 2019 Thunder Laser successfully wrapped up its tour to Tech Industry 2019](https://www.thunderlaserthai.com/wp-content/uploads/2019/12/litaowan3-300x300.jpg)
Thunder Laser successfull…
Release Time:2016/11/11 troubleshooting Browsing Times:2488
1. Firstly run CorelDraw and set the parameter following below instructions:
2. After that, close CorelDraw. Double click to open RDWorks installation program. Choose the type of CorelDraw_Laser (be sure the RDWorks main program has been already installed) sellhouse-asis, and then tick the item RDworks, as shown below:
Click “install” and wait to compete the installation.
3. Again run CorelDraw. Choose and enter “Run Macro”(Tools > Marcos>Run Macro). Choose Marcos in: [Globalmacros (RDWorks15/16/17V8.gms)] > [RDWorksV8.UserInit]. Click run.
4. There will appear two extra buttons . Move them to anywhere you want them to be. After finish drawing the graphics, click “Laser running” to directly import the graphics into RDworks.